How To Use And Store ITO Conductive Glass

How to use and store ITO Conductive glass

ITO conductive glass is a special material with conductive properties that is commonly used in electronic and optical applications. To ensure the optimal performance of ITO conductive glass, it is important to handle and store it correctly. Here are some tips on how to use and store ITO conductive glass:

When taking and putting down ITO conductive glass, it should only be touched on its four sides, avoiding contact with its conductive ITO surface. This minimizes the risk of scratches or damage to its conductive layer.

Handle ITO conductive glass with care, avoiding collisions with other fixtures and machines, as this may cause damage to the glass and affect its performance.

When storing ITO conductive glass for long periods, attention should be paid to moisture, as excessive moisture can affect its resistance and transmittance. It's best to store ITO conductive glass in a dry environment, such as a desiccator or a sealable container with a moisture-absorbing agent.

Cleaning ITO conductive glass:

During production, packaging, and transportation, ITO conductive glass may become contaminated by impurities like dust or grease. Before using ITO conductive glass, it's essential to clean it properly. There are many cleaning methods available, but the most common method is ultrasonic cleaning with organic solvents.

When cleaning grease from the glass surface, it is insoluble in water and requires an organic solvent such as toluene, acetone, or ethanol. Toluene has the strongest degreasing ability among these solvents, so it is typically used first. However, toluene remains on the glass surface after cleaning, and it is soluble in acetone, which allows for further cleaning. Acetone will also remain on the glass surface, and it is soluble in ethanol. Finally, ethanol is soluble in water, allowing for the removal of residual ethanol. The cleaning order is as follows: toluene (10-20 minutes) → acetone (10-20 minutes) → ethanol (10-20 minutes) → deionized water (20-30 minutes).

After cleaning, ITO conductive glass should be preserved in anhydrous alcohol, which ensures that the glass is completely dry and free of impurities. It can then be stored for long periods of time and taken out for use when needed. By following these guidelines, the cleaning and storage of ITO conductive glass can be done effectively, ensuring its optimal performance and longevity.